Lightyear 1/10th EP Touring Car Centre Body Stiffener V2

Introducing our 3D Printed Lightweight Body Stiffener for 1/10 EP Onroad.

Version 2 is direct threaded and slighlty narrower than the standard body width so that you can use the included spacers to get the exact mounting position required.

This stiffener prevents flexing of the sides of the body through high speed corners. It improves downforce and prevents scrubbing speed.

This stiffenener uses carbon rods glued with 3d printed parts. These are designed for use in 190mm touring car bodies for EP such as the Xtreme Twister or Xtreme Red Hawk.

Comes with two screws and various spacers for mounting to the side of the body and a piece of double sided tape to mount to the roof of the bodyshell.

Installation Instructions:

1 - Mount the middle piece to the roof using the included double sided tape. You can also use glue if you prefer. Try to get this as central as possible leaving a small gap on each of the sides.

2- Mark with a pen a small dot through the side pieces. Ream out a hole to 3mm.

3 - Install a screw on each side and screw this into the siffener, use spacers in 1, 2mm or 3mm to get the desired setting.